Gamma 5003 STRINGING MACHINE 2 POINT SC MOUNTING (Issue Manual de usuario

OWNER’S MANUALIssue 5B - February 2014STRINGING MACHINE5003 2 POINT SC MOUNTING

10STRINGING THE FRAMEString Clamp OperationThe string clamps are a dual action design where the string clamp and clamp base oper-ate independently o

11Tensioner Travel StopTo prevent contact between the tension head and the racquet and/or turntable, a travel stop is located about midpoint along the

12STRINGING THE FRAMEGetting StartedTo begin stringing the main strings, thread the two ends of the string through the two center holes at the appro

13STRINGING THE FRAMEWeaving the Cross StringsWeave the cross strings over and under the main strings being careful to alternate the weave direct

14ADDITIONAL FEATURESLocking the TurntableThe turntable may be locked in any position.Rotate the lever down to lock the turntable and up to release th

15PATHFINDER AWLOnce the awl is inserted, pull the handle of the awl outward while holding the tip section in place. This leaves the outer sheath in

16If the lever releases before 60 lbs., using the supplied L-shaped hex wrench, turn the adjustment screw (B) located on the left side of

17MAINTENANCE & ADJUSTMENTSAdjusting the Tensioner BrakeAfter stringing many racquets, the brake of the tensioner may need to be adjusted. Wi

18Adjusting the String Clamp Jaw SpacingThe string clamps will need minor adjust-ments according to what string type, con-struction, and

19TROUBLESHOOTING TIPSCARE & CLEANINGWith time and use, the clamping surfaces of your machine may become oily or dirty and result in string or cl

2LIMITED WARRANTYGAMMA SPORTS (“GAMMA”) warrants to the original purchaser that the GAMMA 5003 stringing machine (“EQUIPMENT”) purchased is free from

20PARTS LIST 6B CAP SCREW- M8x30 104 TENSIONER ASSEMBLY 105 RETAINER SCREW 112 TOOL TRAY 113 LONG LEG 114 SHORT LEG 115 FLAT HEAD SCREW

21PARTS DRAWING1041211151141133201121193373271043366B165289314105116A120A165MDCSC13MQAC12309311285362312390310315283304286313389

22NOTES

23NOTES

GAMMA SPORTS 200 Waterfront DrivePittsburgh, Pennsylvania 15222 Phone: 800.333.0337 Fax: 412.323.0317 Visit our website at www.gammasports.comCopyrig

3FEATURESMACHINE FEATURES Manual Spring Tension Winder with 11 to 89 lbs Tension Range Patented Roller Guide for Maximum Accuracy and Consistency

45003Unpacking Instructions & ContentsInstructions for Unpacking and Preparing for AssemblyThe stringing machine is shipped in two cartons, a Mast

5ASSEMBLY INSTRUCTIONSBase Leg AssemblyThe stringing machine uses a four leg base design. The legs must be assembled to the lower column support befo

6Bellows InstallationThe bellows assembly is supplied in two pieces and should be assembled as follows. Place the bellows section with the fl ang

7ASSEMBLY INSTRUCTIONSInstalling the TensionerRemove the button head screw and washer located at the end of the tensioner bar with the 3mm hex wr

8MOUNTING THE FRAMEAdjusting the Inner Racquet SupportsThe white racquet supports are adjustable to accommodate all racquets and provide maximum suppo

9MOUNTING THE FRAMESpecial Throat Mounting For racquets with a bridge that is thinner than the rest of the frame or are tapered from head to throat