Gamma 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue Manual de usuario

OWNER’S MANUALIssue 5C - February 2014STRINGING MACHINE60042 POINT SC MOUNTING

10STRINGING THE FRAMESetting TensionThe spring tensioner utilizes a rotary adjust-ing knob along with a linear tension scale to indicate the tens

11Travel StopTensioner Travel StopTo prevent contact between the tension head and the racquet and/or turntable, a travel stop is located ab

12STRINGING THE FRAMEADDITIONAL FEATURESLocking the TurntableThe turntable may be locked in any position.Rotate the lever down to lock the turntable

13PATHFINDER AWLOnce the awl is inserted, pull the handle of the awl outward while holding the tip section in place. This leaves the outer sheath in

14BAMAINTENANCE & ADJUSTMENTSIf the lever releases before 60 lbs., using the supplied L-shaped hex wrench, turn the adjustment screw (

15MAINTENANCE & ADJUSTMENTSAdjusting the Tensioner BrakeAfter stringing many racquets, the brake of the tensioner may need to be adjusted. Wi

16Switch Action Clamp Base AdjustmentIf the Switch Action clamp bases slip on the turntable, the base locking levers may need adjusted. Turn the he

17TROUBLESHOOTING TIPSCARE & CLEANINGWith time and use, the clamping surfaces of your machine may become oily or dirty and result in strin

18 98 10MM WRENCH* 109 NEEDLE NOSE PLIERS* 110 BENT NOSE PLIERS* 171 DIAGONAL CUTTERS* 251 HEX WRENCH SET* MA STRINGER’S AWL* MPG START

19MSAC11PARTS DRAWING1211151141133201121193373273366B165283286285289304362310105120A165309313104A116312311MDCSC13390315314389

2TABLE OF CONTENTSWARRANTY ...PAGE 2FEATURES...

GAMMA SPORTS 200 Waterfront DrivePittsburgh, Pennsylvania 15222 Phone: 800.333.0337 Fax: 412.323.0317 Visit our website at www.gammasports.comCopyrig

3FEATURESMACHINE FEATURESManual Spring Tension Winder with 11 to 89 lbs Tension RangePatented Roller Guide for Maximum Accuracy and ConsistencyP

46004Unpacking Instructions & ContentsInstructions for Unpacking and Preparing for AssemblyThe stringing machine is shipped in two cartons, a Mast

5ASSEMBLY INSTRUCTIONSBase Leg AssemblyThe stringing machine uses a four leg base design. The legs must be assembled to the lower column support b

6ASSEMBLY INSTRUCTIONSBellows InstallationThe bellows assembly is supplied in two pieces and should be assembled as follows. Place the bellows

7ASSEMBLY INSTRUCTIONSString Clamp InstallationThe post of the string clamp and tube of the string clamp base are treated with grease to provide prot

8ASSEMBLY INSTRUCTIONSMOUNTING THE FRAMEHeight AdjustmentThe turntable height can be adjusted to suit the stringer. To adjust, loosen the two set

9MOUNTING THE FRAMESpecial Throat Mounting Racquets with a bridge that is thinner than the rest of the frame or are tapered from hea