Gamma 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue Manual de usuario descargar pdf (Pagina 8)

ASSEMBLY INSTRUCTIONS

MOUNTING THE FRAME

Height Adjustment

The turntable height can be adjusted to suit

the stringer. To adjust, loosen the two set

screws on the lower column support post

below the bellows assembly. Adjust the

amount of engagement between the upper

and lower column supports until the desired

height is attained. Make sure that the tension

track is still aligned with the long leg of the

base and tighten the two set screws to lock

the upper support column into place.

Adjusting the Inner Racquet Supports

The white racquet supports are adjustable to accommodate

all racquets and provide maximum support to the racquet

frame. Screw the pads up or down so they contact the

frame at a maximum height without blocking the grommet

holes.

Mounting Stand Adjustment

When mounting a racquet, adjust the

Mounting Stands so that the white Racquet

Supports on top of the Mounting Stands ﬁ t

inside the hoop of the racquet. Lower the

racquet over the Racquet Supports and ad-

just the Mounting Stands until the supports

just make contact with the inside surface of

the racquet at the head and throat. There is

an arrow on the face of each knob indicat-

ing the turning direction that will “Tighten”

the mounting points by moving the 2pt

Mounting Stands further apart to bring the

Racquet Supports closer to the inside surface of the racquet at the head and throat. Turning

the knobs in the opposite direction will move the Mounting Stands closer together and will

allow the Racquet Supports to move away from the racquet frame.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Gamma 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue Manual de usuario Pagina 8